|
[ Futaba 8U ] [ Futaba 7C ] [ Futaba 9C ] [ Futaba 9Z ] [ Futaba 12Z ] [ Futaba 14MZ ]
| |
![[Product Image]](Black%209Z%20Standarda.jpg)
![[Product Image]](Blue%209Z%20G2a.jpg)
Cyclic
Ring - 9Z Standard
Cyclic Ring - 9Z Generation 2
* DUE TO THE POPULARITY OF OUR
GENERATION 2 (G2) CYCLIC RINGS, STANDARD ROUND RINGS HAVE BEEN DISCONTINUED
AS STOCK PRODUCT. CUSTOM ORDERS WILL BE ACCEPTED.
-
Cyclic Rings help to reduce or eliminate the
binding of cyclic servos and linkage in corner axi of the cyclic control.
-
Ifinavation Cyclic Rings come with pre-applied
double sided tape for easy test fit and installation.
-
The Standard Cyclic Ring provides equal travel
in all cyclic directions.
-
The Generation 2
Cyclic Ring provides further range of movement. (For example it
provides more constant roll rate while using elevator control for
maintaining forward speed and or attitude.)
-
Available for Futaba 7C, 8U, 9C, 9Z, 12Z, and 14MZ.
Choose your transmitter for a list of available options.
Cyclic Ring
(C/R) Mounting Directions for Futaba 7C, 8U, 9C, and 9Z
-
Test fit C/R before removing tape liner.
-
If
Generation 2,
be sure to put the notch toward bottom.
-
Adjust stick length/alignment so the lower, tapered portion of stick makes
contact with the C/R.
-
Add
supplied spacer between lower and upper stick to adjust length if needed.
(The spacer can be filed for custom stick length.)
-
After test fit, clean TX
surface, remove mounting tape liner and apply C/R to TX.
|
